TMS zl Management and Configuration Guide ST.1.1.100226

A-188
Command-Line Reference
Product OS Show Commands
show high-availability
This command shows the HA configuration.
Syntax: show high-availability
show ip
This command shows interface information as well as routing information.
To view the IP addresses that are assigned to TMS VLANs (as well as the
VLANs’ zone), enter this command:
Syntax: show ip
You can also add options to this command to view information about:
■ RIP
■ OSPF
■ The routing table
■ The multicast routing table
■ PIM
■ IGMP configuration
■ DNS server settings
The sections below document these options.
show ip rip
The show ip rip command shows information about RIP on the network. You
can view:
■ Redistribution
■ RIP on a particular interface
■ (Optional) RIP peers
■ Restrictions
To view RIP redistribution, enter the following command:
Syntax: show ip rip redistribute
To view RIP on a particular interface, enter the following command:
Syntax: show ip rip interface [ <IP address> | vlan <VLAN ID> ]
Replace <IP address> with the interface IP address.