TMS zl Management and Configuration Guide ST.1.1.100226

A-190
Command-Line Reference
Product OS Show Commands
To view OSPF on a particular interface, enter the following command:
Syntax: show ip ospf interface [ <IP address> | vlan <VLAN ID> ]
Replace <IP address> with the interface IP address.
Replace <VLAN ID> with the VLAN ID.
To view the module’s OSPF neighbors, enter the following command:
Syntax: show ip ospf neighbor
To view the module’s grace link-state, enter the following command:
Syntax: show ip ospf data grace-link-state
To view OSPF redistribution, enter the following command:
Syntax: show ip ospf redistribute
To view restricted addresses, enter the following command:
Syntax: show ip ospf restrict
show ip route
To view the TMS zl Module’s routing table, enter the following command
Syntax: show ip route
This command displays:
■ Destination—Each network to which the module knows a route
■ Gateway—The IP address of the next-hop router in the path to this
network
■ Metric—The cost for the route
■ Distance—The administrative distance for the route
■ VLAN—The forwarding VLAN for the route
■ Type—The method by which the route was discovered or configured
show ip mroute
To view the TMS zl Module’s multicast routing table, enter the following
command:
Syntax: show ip mroute
This command displays: