TMS zl Management and Configuration Guide ST.1.1.100226

2-34

Initial Setup in Routing Mode

Configure Management Access

This section explains how to configure management access on the TMS zl

Module, as well as how to navigate the module’s Web browser interface.

Configure Initial Settings

Before you can access the Web browser interface and begin configuring the

TMS zl Module, you must configure some initial settings. Specifically, you must

access the CLI and complete these tasks:

■ Enable management access on a zone.

■ Optionally, configure a priority VLAN.

■ Associate a VLAN with the zone.

■ Configure a static IP address for the VLAN.

■ Configure the default gateway.

To begin configuring management access, complete these steps.

1. Access the host switch’s CLI. If you do not remember the index number

for the TMS zl Module, enter this command:

hostswitch# show services

2. Enter the Product OS context:

hostswitch# services <slot ID> <product index>

Replace <slot ID> with the letter of the chassis slot in which the module is

installed.

Replace <product index> with the TMS zl Module’s letter of the chassis slot

in which the module is installed.

The prompt should look like the following:

hostswitch(tms-module-C)#

3. Enter the global configuration context for the module:

hostswitch(tms-module-C)# configure terminal

Syntax: configure terminal

Enters the configuration context for the module.