TMS zl Management and Configuration Guide ST.1.1.100226

2-36
Initial Setup in Routing Mode
Configure Management Access
5. Associate a VLAN with the management-access zone:
When you first set up management access for the module, associate your
management workstation’s VLAN with the management-access zone that
you just enabled.
For example, enter this command to associate VLAN 5 with the Internal
zone:
hostswitch(tms-module-C:config)# vlan 5 zone internal
Note If you have configured a dedicated management VLAN on the module’s host
switch, you may want to associate that management VLAN with the manage-
ment-access zone.
In that case, add allow-switch-ip to the command to permit the switch to have
an IP address on that VLAN:
hostswitch (tms-module-C:config)# vlan 5 zone internal
allow-switch-ip
To follow best security practices, the management VLAN should not be the
default VLAN (which is VLAN 1).
Figure 2-13. Initial Setup Example
Syntax: vlan <VLAN ID> zone <zone>
Associates a VLAN with a zone.
Replace <VLAN ID> with the number of a VLAN to associate
with the zone.
Replace <zone> with the name of a zone.