TMS zl Management and Configuration Guide ST.1.1.100226

2-42
Initial Setup in Routing Mode
Configure Management Access
For example, you might enter:
hostswitch (tms-module-C:config)# ping
10.1.99.101
PING 10.1.99.101 (10.1.99.101) 56(84) bytes of
data.
64 bytes from 10.1.99.101: icmp_seq=1 ttl=255
time=1.54 ms
64 bytes from 10.1.99.101: icmp_seq=2 ttl=255
time=0.515 ms
64 bytes from 10.1.99.101: icmp_seq=3 ttl=255
time=0.526 ms
12. Save the configuration on the TMS zl Module:
Note For the TMS zl Module, the write memory command saves the configurations
that have been made in all contexts.
13. On the default gateway (the router or routing switch), create a route or
routes to the TMS VLANs. The routes’ next hop should be the TMS zl
Module’s IP address on the VLAN that you just added.
See Appendix A: “Command-Line Reference” for a complete list of CLI com-
mands for the TMS zl Module.
Access the Web Browser Interface
To access the Threat Management Services zl Module’s Web browser interface
through a secure HTTPS session, you will need you will need a supported Web
browser:
■ Firefox 2.x or higher
■ Internet Explorer 7 or higher
Additionally, JavaScript must be enabled on your Web browser.
In the address bar, type https:// followed by your module’s IP address. For
example, if your module has the IP address 192.168.2.102, type https://
192.168.2.102.
Syntax: write memory
Saves the running-config to the startup-config.