TMS zl Management and Configuration Guide ST.1.1.100226

2-54
Initial Setup in Routing Mode
Configure Management Access
Note The connections listed in the Firewall section include both passive and active
connections. Passive connections are how the firewall reserves connections
for ALGs and configured reservations.
You should not be concerned with the number of connections, unless:
■ The maximum connection threshold for a zone is reached
■ The number of connections is unreasonably high
In these cases, you can access the module’s CLI and enter the show connections
command to view only the active connections. For more information about
this command, see “show connections” in Appendix A: “Command-Line
Reference.”
Table 2-10. Information in the Network Interfaces Tab on the TMS zl Module
Dashboard
Field Description How to Configure
Network Interfaces
Name Name of the TMS VLAN or GRE tunnel
Network > Settings > Zones
See “Plan the Zones” on page 2-8.
VPN > GRE > Zones
See “Configure a GRE Tunnel” in Chapter 7: “Virtual
Private Networks.”
Status UP or DOWN; describes whether the
interface is functioning
n/a
IP/Mask The IP address and network mask for the
TMS zl Module's interface on the
TMS VLAN or GRE tunnel
Network > Settings > Zones
See “Plan the Zones” on page 2-8.
VPN > GRE > Zones
See “Configure a GRE Tunnel” in Chapter 7: “Virtual
Private Networks.”
Received Number of kilobytes per second that are
being received on the interface
n/a
Sent Number of kilobytes per second that are
being sent on the interface
n/a