TMS zl Management and Configuration Guide ST.1.1.100226

2-55
Initial Setup in Routing Mode
Configure Management Access
Integrate with PCM+
You can manage the TMS zl Module through HP ProCure Manager Plus
(PCM+) just as you can manage any other network device.
To manage your module through PCM+, you must configure a few settings on
the TMS zl Module first:
1. Associate the PCM+ server’s VLAN with a zone, preferably a management-
access zone. (“Plan the Zones” on page 2-8.)
2. If the PCM+ server is not in a management-access zone, you should
configure firewall access policies to permit at least ICMP/Echo, SNMP,
SNMP traps, Telnet, SSH, and HTTPS traffic to the PCM+ server.
You should also create any other policies that PCM+ and the TMS zl
Module will need to communicate. The necessary policies depend on how
you are using the devices on your network.
3. Configure SNMPv1/2c with the PCM+ server’s community names or
SNMPv3 with a management account.
For more instructions on managing the TMS zl Module through PCM+, see the
ProCurve Manager Network Administrator’s Guide, version 3 or later.
To integrate with HP ProCurve Network Immunity Manager (NIM), see “Inte-
gration with HP ProCurve Network Immunity Manager” in Chapter 6: “Intru-
sion Detection and Prevention.”
Modify the TMS zl Module’s Management Settings
To access the Web browser interface, you configured a set of management
settings. You enabled management access on a zone, added a VLAN to that
zone, and configured a static IP address for the VLAN. The TMS zl Module
allows you to manage the module from as many zones as you want, so you can
specify additional zones as management-access zones.
To view and change the module’s management access on the zones, complete
the following steps.
1. Click Network > Zones and click the Management Access tab.