TMS zl Management and Configuration Guide ST.1.1.100226

2-56
Initial Setup in Routing Mode
Configure Management Access
Figure 2-26. Network > Zones > Management Access Window
2. Select the check boxes for the zones from which you want to permit
management traffic to the module. Conversely, clear the check boxes for
the zones where you want to deny management access.
3. Click Apply My Changes.
The module now automatically creates all of the access policies necessary
to permit management traffic from the zones that you selected, as shown
in Table 2-11 and Table 2-12.
4. Click Save.
Note If you clear the check box for the zone from which you are currently connected
to the module and click Apply My Changes, you will lose connectivity from the
Web browser interface. Once disconnected, you will need to reconnect to the
module from a zone that has management access enabled, or you will have to
access the CLI through a serial console to the host switch and enable manage-
ment access from at least one zone.