TMS zl Management and Configuration Guide ST.1.1.100226

2-59
Initial Setup in Routing Mode
Configure Management Access
6. For Metric, type the cost that you want to assign to the route (0 to 255). If
you want this route to be less preferred than another default route, assign
it a higher metric.
7. For Distance, type the administrative distance that you want to assign to
this route (1 to 255). If you want this route to be less preferred than
another default route, assign it a higher administrative distance.
When the TMS zl Module determines the preference for two identical
routes, it first checks the administrative distance. If this value is the same,
it checks the metric.
8. Click OK.
9. Click Save.
Change the Operating Mode
The operating mode described in this chapter is routing. Because this is the
default operating mode, you should not need to change it. However, if for
whatever reason the current operating mode is monitor, follow these steps to
change the mode:
1. Click System > Settings and click the Operating Mode tab.
Figure 2-28. System > Settings > Operating Mode Window
2. Select Routing. See “Operating Modes” in Chapter 1: “Overview” for an
explanation of the operating modes.
3. Click Apply My Changes.
4. A warning box is displayed, informing you that you must reboot the TMS
zl Module to apply the change:
•Click Save & reboot to save your configuration changes and reboot the
TMS zl Module.