TMS zl Management and Configuration Guide ST.1.1.100226

2-77
Initial Setup in Routing Mode
Configure Management Access
If you want to add more SNMP v3 trap receivers, repeat these steps. Use the
Edit and Delete icons in the Tools column to modify or remove a trap receiver.
Configure SNMP
The TMS zl Module allows some remote management through SNMPv1/v2c or
SNMPv3. For example, you can configure SNMP so that the module can be
managed by PCM+. If you are going to allow remote management through
SNMP, make sure that you configure the parameters on the TMS zl Module to
match those configured on the SNMP server.
To configure SNMP settings, click System > Settings and click the SNMP tab.
Figure 2-45. System > Settings > SNMP Window
SNMPv1/v2c
To configure SNMPv1/v2c settings, complete the following steps:
1. You should be in the System > Settings > SNMP window.
2. Select Enable SNMPv1/v2.
Two default communities are enabled:
■ Public:
• Role = Manager
• Write Access = Restricted