TMS zl Management and Configuration Guide ST.1.1.100226

2-79
Initial Setup in Routing Mode
Configure Management Access
5. Click OK.
6. Click Save.
If you want to add more SNMPv1/v2 communities, repeat these steps.
Note Remember: if you choose to add new communities rather than edit the default
communities, the default communities will continue to allow access unless
you delete them. To delete a community, click the Delete (X) icon in the Tools
column for that community.
SNMPv3
To configure SNMPv3 settings, complete the following steps:
1. From the System > Settings > SNMP window, select Enable SNMPv3.
2. Under Enable SNMPv3, click Add another user. The Add SNMPv3 User win-
dow is displayed.
Figure 2-48. Add SNMPv3 User Window
3. For User Name, type the SNMPv3 username for the account.
The username must match a username in an account on the SNMPv3
server. The remaining settings must also match the settings in that
account.
4. For Role, select the role of the account: Manager (read/write) or Operator
(read only).