TMS zl Management and Configuration Guide ST.1.1.100226

2-88
Initial Setup in Routing Mode
Ping Utility
Figure 2-54. Add Policy Window
10. Click Apply, and then click Close.
Sending a Ping from the TMS zl Module
To ping an IP address or hostname, complete the following steps:
1. Click System > Utilities > Ping.
2. For Hostname/IP Address, type the hostname or IP address of the device
you are trying to reach.
3. For Repetitions, select the number of ping messages you want to the
module to send.
You can configure a maximum of 10 repetitions from the Web browser
interface. If you want a higher number of repetitions, you can enter the
ping command from the CLI, which supports a maximum of 10,000
repetitions.
4. For Data Size, type the number of bytes you want to be included in each
ping packet sent (0–65471).