TMS zl Management and Configuration Guide ST.1.1.100226

3-24
Initial Setup in Monitor Mode
Configure Management Access
2. Enter the configuration context for the module:
hostswitch(tms-module-C)# configure terminal
3. Set the operating mode to monitor:
You will be prompted to confirm that you want to change operating modes
and asked if you want to save the current configuration.
hostswitch(tms-module-C:config)# operating-mode
monitor
Changing the operating mode requires a reboot to take
effect. Do you want to continue [y/n]? y
Do you want to save the current configuration [y/n]? y
4. Configure the management VLAN:
For example:
hostswitch(tms-module-C:config)# management vlan 2
Note You may want to set the management VLAN of the TMS zl Module to match
the management VLAN of the switch, if any. The management VLAN, however,
should not be the default VLAN: VLAN 1.
5. Set a static IP address for the module’s management interface:
Syntax: configure terminal
Enters the configuration context for the module.
Syntax: operating-mode monitor
Enters the configuration context for the module.
Syntax: management vlan <VLAN ID>
Sets the VLAN for management and HA traffic.
Syntax: management ip <ip address> <mask>
Sets a static IP address for the module’s management
interface.
Replace <IP address> with the IP address for the module’s
management interface.
Replace <mask> with the number of bits in the subnet
mask.