TMS zl Management and Configuration Guide ST.1.1.100226

3-25
Initial Setup in Monitor Mode
Configure Management Access
For example:
hostswitch(tms-module-C:config)# management ip
address 10.1.5.111 255.255.255.0
Note The management IP address should be static. Do not use DHCP to obtain this
address.
6. To set the default gateway, enter the following command:
For example:
hostswitch(tms-module-C:config)# ip route 0.0.0.0/0
10.1.5.1
See Appendix A: “Command-Line Reference” for a complete list of CLI com-
mands for the TMS zl Module.
You can now access the module using the Web browser interface by typing
the IP address of the management VLAN in the browser’s address bar. See the
following section, “Access the Web Browser Interface.”
Access the Web Browser Interface
To access the Threat Management Services zl Module’s Web browser interface
through a secure HTTPS session, you will need you will need a supported Web
browser:
■ Firefox 2.x or higher
■ Internet Explorer 7 or higher
Additionally, JavaScript must be enabled on your Web browser.
In the address bar, type https:// followed by your module’s IP address. For
example, if your module has the IP address 192.168.2.102, type https://
192.168.2.102.
Note If you are running Firefox 3, ensure that you have an ActiveX plug-in; other-
wise, some of the features in the Help Files will not function.
Syntax: ip route 0.0.0.0/0 <next-hop address>
Sets a default gateway for the module.
Replace <next-hop address> with the IP address of the
default gateway for the module.