TMS zl Management and Configuration Guide ST.1.1.100226

3-35
Initial Setup in Monitor Mode
Configure Management Access
Integrate with PCM+
You can manage the TMS zl Module through the HP ProCure Manager Plus
(PCM+) just as you can manage any other network device.
To manage your module through a PCM+, you must configure SNMPv1/2c with
the PCM+ server’s community names or SNMPv3 with a management account.
(See “Configure SNMP” on page 3-55.)
For more instructions on managing the TMS zl Module through PCM+, see the
ProCurve Manager Network Administrator’s Guide, version 3 or later.
To integrate with HP ProCurve Network Immunity Manager (NIM), see “Inte-
gration with HP ProCurve Network Immunity Manager” in Chapter 6: “Intru-
sion Detection and Prevention.”
Latest Critical Alerts
List of alerts with the severity level of
Critical, with the most recent alert at the
top
n/a; See all alerts on
System > Logging > View Log
Network Interfaces
Name Name of the TMS zl Module physical port. See “Ready the Host Switch” on page 3-7.
Status UP or DOWN; describes whether the
interface is functioning
n/a
IP/mask The IP address and network mask for the
TMS zl Module on the port.
See “Configure Initial Settings” on page 3-23.
Received Number of kilobytes per second that are
being received on the port
n/a
Sent Number of kilobytes per second that are
being sent on the port
n/a
Intrusion Detection
Packets Inspected Number of packets per second that the IDS
is currently inspecting
n/a
Critical Events Number of critical events per second that
the IDS is currently logging
n/a
Severe Events Number of severe events per second that
the IDS is currently logging
n/a
Warning Events Number of warning events per second that
the IDS is currently logging
n/a
Info Events Number of information events per second
that the IDS is currently logging
n/a
Field Description How to Configure