TMS zl Management and Configuration Guide ST.1.1.100226

3-37
Initial Setup in Monitor Mode
Configure Management Access
Configure the Default Gateway
Typically, you should configure the default gateway as part of the initial set up
from the CLI; however, you can also configure the default gateway from the
Web browser interface. You can also add a second default gateway. In this
case, the metric and administrative distance for the two default routes will
determine which is preferred.
Follow these steps:
To set the default gateway, follow these steps:
1. Select Network > Routing > Static Routes.
2. Click Add static route.
Figure 3-18. Add static route Window
3. For Destination Type, select Default Gateway.
4. For Gateway Address, type the IP address of the default gateway.
5. For Metric, type the cost that you want to assign to the route (0 to 255). If
you want this route to be less preferred than another default route, assign
it a higher metric.
6. For Distance, type the administrative distance that you want to assign to
this route (1 to 255). If you want this route to be less preferred than
another default route, assign it a higher administrative distance.