TMS zl Management and Configuration Guide ST.1.1.100226

3-38
Initial Setup in Monitor Mode
Configure Management Access
When the TMS zl Module determines the preference for two identical
routes, it first checks the administrative distance. If this value is the same,
it checks the metric.
7. Click OK.
8. Click OK.
9. Click Save.
Create a Static Route
Typically, its default gateway can perform all the routing that a monitor mode
TMS zl Module requires. However, if you need, you can create a static route
to a specific network or host through a different gateway. Follow these steps:
1. Access the Network > Routing > Static Routes window.
2. Click Add Static Route. The Add Static Route window is displayed.
Figure 3-19. Add Static Route Window
3. For Destination Type, select the destination type: Network or Host.
4. The Destination Address depends on the destination type that you chose:
• Network—type the IP address and subnet mask of the destination.
• Host—type the IP address of the host.
5. For Gateway Address, type IP address of the next-hop router.