TMS zl Management and Configuration Guide ST.1.1.100226

3-45
Initial Setup in Monitor Mode
Configure Management Access
Note Again, it is best practice to add Service-Type = NAS-Prompt-User to the
selection criteria for the management access policy.
• It sets the following AVP for the connection: Service-Type = NAS
Prompt.
Table 3-8. RADIUS Attributes Sent in Management Access RADIUS Request
Configure DNS
To configure the DNS server settings, complete the following steps:
1. Select Network > Settings > General.
Figure 3-25. Network > Settings > General Window
2. For Primary Server, type the IP address of your primary DNS server.
Attribute Value
Username Username submitted in the log in window
Password Password submitted in the log in window
Calling-Station-ID User’s IP address
NAS-Identifier NAS Identifier configured for the module when you
specified the RADIUS server
NAS-IP-Address Module IP address on the TMS VLAN that connects
to the RADIUS server
Service-Type NAS-Prompt-User