TMS zl Management and Configuration Guide ST.1.1.100226

3-52
Initial Setup in Monitor Mode
Configure Management Access
Configure SNMP Traps
SNMP traps are unsolicited messages that are sent by managed devices to alert
you about specific events. For example, you can use PCM+ to manage the
TMS zl Module by specifying the device running PCM+ as a trap destination.
The TMS zl Module supports the standard MIB-II, the IF-MIB, and a proprie-
tary MIB that is particular to the operation of the TMS zl Module.
Note If you configure SNMP traps from the PCM+ interface instead of from the
TMS zl Module interface, the module will send only MIB-II and IF-MIB traps
to the PCM+ server, not proprietary MIB traps. The proprietary MIB can be
found in the help files on the module.
To configure SNMP traps, click System > Logging and click the SNMP Traps tab.
Figure 3-33. System > Logging > SNMP Traps Window
To enable SNMP traps, do one or both of the following:
■ Select the Enable SNMPv2 traps check box.
■ Select the Enable SNMPv3 traps check box.
Add an SNMPv2 Trap Destination. To add an SNMPv2 trap destination
(such as PCM+), complete the following steps:
1. Under Enable SNMPv2 traps, click Add another destination. The Add SNMPv2
Destination window is displayed.