TMS zl Management and Configuration Guide ST.1.1.100226

3-65
Initial Setup in Monitor Mode
System Maintenance
You cannot uninstall and reinstall software from the Web browser interface.
To restore the module to the factory default configuration from the Services
OS context, complete the following steps:
1. Access the Services OS context:
2. Boot the Services OS:
3. When asked if you would like to reboot the module, type
[y].
For example:
hostswitch(services-module-C:PR)# boot service
System will be rebooted. Do you want to continue
[y/n]? y
Rebooting
4. Once the module has rebooted, enter the Services OS context again:
hostswitch# services c 1
5. See which software images are stored on the module.
For example:
hostswitch(services-module-C:HD)# show images
--------Image Repository---------
1) ST.3.2.090315
2) ST.3.3.090821
3) ST.3.4.091103
6. If the latest software image is not in the image repository, follow steps
1 through 9 in “Update the Software with USB Drive” on page 3-71 to
transfer the image folder to the module.
Syntax: services <slot ID> 1
Enters the Services OS context on the module.
Replace <slot ID> with the letter for the chassis slot in which
the module is installed.
Syntax: boot service
Boots the Services OS.
Syntax: show images
Shows the images that are stored in the image repository.