TMS zl Management and Configuration Guide ST.1.1.100226

3-70
Initial Setup in Monitor Mode
System Maintenance
4. After you press [Enter], the module prompts you for a password. Enter the
password for the user that you specified in the command. For example:
Password: procurve
5. The image is copied to the module, then automatically installed. When the
prompt says that the installation is finished, reboot the module to com-
plete the update.
hostswitch(tms-module-C)# boot
Update the Software from a TFTP Server. To update the module soft-
ware using a TFTP server, do the following:
1. Transfer the compressed image onto a TFTP server.
2. Access the TMS zl Module Product OS in one of the following two ways:
• Through the host switch CLI:
i. Access the host switch CLI and enter the manager context.
ii. Enter the Product OS context for the TMS zl Module:
• Through SSH:
i. Open an SSH client on a management workstation in a manage-
ment-access zone.
ii. Establish a connection to a TMS zl Module IP address.
iii. If prompted, accept the module’s key.
iv. When prompted for a username, enter manager.
If you are using a RADIUS server to authenticate management
users, you can alternatively enter the username for a user with
manager (Administrative) access.
v. When prompted for a password, enter the manager user’s pass-
word.
Syntax: services <slot ID> <product index>
Moves you to an OS context on the module.
Replace <slot ID> with the letter for the chassis slot in which
the module is installed.
Replace <product index> with the index number that your
particular switch has assigned the TMS zl Module.