TMS zl Management and Configuration Guide ST.1.1.100226

5-21
Network Address Translation
Configuring NAT Policies
12. Click OK.
13. If necessary, create a firewall access policy with the same source and
destination zones as the NAT policy you just created and that permits the
same services and addresses. (See “Firewall Access Policies for NAT” on
page 5-23.)
14. Click Save.
Exclusion NAT Policies
To add an exclusion NAT policy, follow these steps:
1. Click Firewall > NAT Policies > Policies.
2. Click Add Policy.
3. Select None for translation type.
Figure 5-8. Add NAT Policy Window
4. For From Zone, select the zone where traffic originates. (See “Plan the
Zones” in Chapter 2: “Initial Setup in Routing Mode.”)
5. For To Zone, select the zone where traffic is destined.