TMS zl Management and Configuration Guide ST.1.1.100226

7-123
Virtual Private Networks
Configure an IPsec Site-to-Site VPN with Manual Keying
See “Named Objects” in Chapter 4: “Firewall” for step-by-step instructions for
configuring objects.
Table 7-11. Possible Named Objects for an IPsec Site-to-Site VPN with Manual
Keying
Figure 7-104. Example IPsec Site-to-Site VPN
Create an IPsec Proposal
Each IPsec proposal specifies the following:
■ IPsec mode (tunnel or transport)
■ IPsec security protocol:
• AH and a single authentication algorithm
• ESP, a single authentication algorithm, and a single encryption
algorithm
Figure
Reference
Named Object Type Named Object Description Location Where the Named
Object is Specified
2 Single-entry IP, range, or network
address objects
The IP addresses of local
endpoints that are allowed to send
traffic over the VPN
• Local Address in the IPsec
policy traffic selector
• Source or Destination for
firewall access policies that
permit traffic sent across the
VPN
4 Single-entry or multiple-entry IP,
range, or network address objects
The IP addresses of endpoints
behind the remote VPN gateway
• Remote Address in the IPsec
policy traffic selector
• Source or Destination for
firewall access policies that
permit traffic sent across the
VPN