TMS zl Management and Configuration Guide ST.1.1.100226

7-138
Virtual Private Networks
Configure an IPsec Site-to-Site VPN with Manual Keying
Figure 7-118. Add Policy Window
g. Click the Advanced tab.
h. For TCP MSS, type the value that you determined is best for your
system. For example, type 1356.
i. Click the Basic tab.
j. Click Apply.
5. Permit traffic from the remote endpoints to the local endpoints:
a. For Action, leave the default, Permit Traffic.
b. For From, select the remote zone.
c. For To, select the local zone.
d. For Service, leave Any Address.
This is the most basic configuration. You could also create access
policies that permit only certain services.
e. For Source, specify the remote IP addresses allowed to send traffic
on the VPN.
You can specify the addresses manually or select a previously config-
ured address object.
f. For Destination, specify the local addresses which the remote users
are allowed to access.