TMS zl Management and Configuration Guide ST.1.1.100226

7-308
Virtual Private Networks
GRE Examples
Figure 7-265. Add Area Window
6. For Area ID, type 2.
7. For Area Type, select STUB.
8. For Metric, type 5.
9. Click OK.
Finally, enable OSPF on the VLAN interface for the local network.
10. Click Enable OSPF on an interface. The Enable OSPF on a Interface window
is displayed.
11. For Interface, select VLAN 70 (VLAN70).
12. For Area ID, type 2.
13. Accept the default values for the remaining options.
14. Click OK.
15. Click Save.
Configure Firewall Access Policies for Site A
You must configure policies that do the following:
■ Permit GRE messages to the remote gateway.
■ Permit GRE messages from the remote gateway.
■ Permit traffic from the local endpoints to the remote endpoints.
■ Permit traffic from the remote endpoints to the local endpoints.
If you want to disable the default OSPF policies and limit OSPF traffic to
specific IP address, you must configure policies that do the following: