TMS zl Management and Configuration Guide ST.1.1.100226

7-367
Virtual Private Networks
Configure an HP ProCurve VPN Client
3. Right-click the My Connections folder and click Add > Connection.
4. Type a meaningful name for the new connection.
5. If you desire, under Connection Security, select the Only Connect Manually
check box.
Figure 7-313. Security Policy Editor Window (Connection Added)
6. Under Remote Party Identity and Addressing, you specify the addresses in
the internal network that the remote client can reach. These settings must
match the local addresses in the traffic selector of the TMS zl Module’s
IPsec policy:
a. For ID Type, select the type of value or object configured for the Local
Address in the module’s traffic selector.
For example, the module’s IPsec policy traffic selector allows traffic
to a single local IP address. In the ProCurve VPN Client, select IP
Address for the ID Type.
If, on the other hand, the module’s IPsec policy traffic selector allows
traffic to a complete local subnet or a range of IP addresses, you select
IP Subnet or IP Address Range.