TMS zl Management and Configuration Guide ST.1.1.100226

7-368
Virtual Private Networks
Configure an HP ProCurve VPN Client
b. Boxes are displayed depending on the ID Type that you selected. Type
a string that exactly matches the value in the Local Address of the
module’s IPsec policy traffic selector.
c. For Protocol, match the protocol selected in the module’s IPsec policy
traffic selector.
If the module’s setting is Any, leave the default All.
d. If you selected TCP or UDP for Protocol, for Port, select a service that
matches the Local Port in the TMS zl Module’s IPsec policy traffic
selector.
7. Select the Connect Using Secure Gateway Tunnel check box.
8. For ID Type, select the local ID type in the module’s IKE policy. Then type,
in the box below, the local ID value in the module’s IKE policy.
If you select Distinguished Name, you must click Edit Name. Then select the
Enter Subject Name in LDAP format check box and type the name. For
example, type CN=TMS.procurveu.edu.
9. If you selected Domain Name or Distinguished Name for the ID Type, type
the TMS zl Module’s public IP address under Gateway IP Address.
This IP address must be the Local Gateway IP Address in the module’s IKE
policy. Typically, it is the module’s IP address on a VLAN in the External
zone.
Figure 7-314. ProCurve VPN Client—Security Policy Editor