TMS zl Management and Configuration Guide ST.1.1.100226

7-390
Virtual Private Networks
Configure IPSecuritas (Macintosh VPN Client)
Figure 7-334. IPSecuritas—Connections > Phase 2 Tab
17. Click the ID tab and configure the following settings, which correspond
to the identities and authentication method in the TMS zl Module IKE
policy:
a. Local Identifier—Select the identity type for the local endpoint (remote
ID on the module) and type the value in the box provided, if any:
i. User FQDN—Specify an email address in the box.
ii. FQDN—Specify a domain name in the box.
iii. Address—The Macintosh client’s IP address is used automatically.
iv. Certificate—Select this option if you are using certificates for
authentication. The identity type and value is taken from the
certificate that you installed previously.
b. Remote Identifier—Select the identity type for the TMS zl Module
(local ID on the module) and type the value in the box provided, if any:
i. User FQDN—Specify an email address in the box.
ii. FQDN—Specify a domain name in the box.
iii. Address—The client automatically uses the address that you spec-
ified for the Remote IPSec Device in step 12 on page 7-387.
iv. Certificate—Select this option if you are using certificates for
authentication. The identity type and value is taken from the
certificate that you installed previously.