TMS zl Management and Configuration Guide ST.1.1.100226

7-488
Virtual Private Networks
Configure a Windows Vista Client for L2TP over IPsec
Figure 7-442. Windows Vista—<Connection>
Properties Window > Networking Tab
90. Select Internet Protocol Version 4 (TCP/IPv4) in the This connection uses the
following items box and click Properties.
91. Ensure that Obtain an IP address automatically and Obtain DNS server address
automatically are selected so that the TMS zl Module can assign these
values while the client is visiting the private network. Click OK to exit.
92. Click OK to close the <connection> Properties window.
93. In the The connection is ready to use page, double-click Connect now.
After a minute or so, you should see a message that informs you that the
connection was successful.
TMS zl Module Settings for a Windows Vista Client
Table 7-42 displays the settings that should be established on the TMS zl
Module to support the L2TP over IPsec connection. The table also displays
necessary firewall policies. Also note that VLANs and necessary routes should
already be in place on the TMS zl Module.