TMS zl Management and Configuration Guide ST.1.1.100430

8-16
High Availability
Configuring High Availability
hostswitch(tms-module-D:config)# show zones
You can see that there is a single connection originating in Zone1 on both the
master and the participant.
Disabling a Cluster
When disabling an HA cluster, you must complete the following tasks in the
order listed:
■ Remove the cluster participant (See “Remove Cluster Participant” on
page 8-16.)
■ Remove the cluster master (See “Remove Cluster Master” on page 8-18.)
Remove Cluster Participant
When disabling the cluster, you should always remove the participant from
the cluster first. Because the participant does not have any IP addresses while
it is part of the cluster, you must use the participant’s CLI to remove it.
To remove an HA cluster participant, follow these steps:
1. Initiate a console session with the participant's host switch.
Zone
-----------------
Connections
------------
Limit
-------
SELF 0 21428
EXTERNAL 0 150000
INTERNAL 0 150000
DMZ 0 150000
ZONE1 1 21428
ZONE2 0 21428
ZONE3 0 21428
ZONE4 0 21428
ZONE5 0 21428
ZONE6 0 21428
----------------- ------------ -------
Total 1 599996