TMS zl Management and Configuration Guide ST.1.1.100430

9-40
Routing
OSPF
■ Define NSSA, stub, and total stub areas
Enable OSPF
To enable OSPF, click Network > Routing and click the OSPF tab.
Figure 9-12. Networking > Routing > OSPF Window
1. Select the Enable OSPF check box.
2. Click Apply My Changes.
Set the Router ID
When OSPF routers exchange certain types of messages, they include their
router ID. Routers piece messages together into a coherent network topology.
They can only complete this task if each router’s ID is unique, consistent, and
significant for the entire network. The TMS zl Module likely has several
different TMS VLANs, each with its own IP address. You must select a single
address for OSPF to consistently identify the module.
To configure the router ID, click Network > Routing and click the OSPF tab.