TMS zl Management and Configuration Guide ST.1.1.100430

9-44
Routing
OSPF
Figure 9-14. Enable OSPF on an Interface Window
3. For Interface, select an interface from the list. The interfaces listed are
TMS VLANs and GRE tunnels (on which OSPF has not already been
enabled).
To learn how to create TMS VLANs, see “Plan the Zones” in Chapter 2:
“Initial Setup in Routing Mode.” To learn how to create GRE tunnel
interfaces, see, “Configure a GRE Tunnel” in Chapter 7: “Virtual Private
Networks.”
4. For Area ID, type the area to which you want to assign the interface.
For Area ID, you can use integer or dotted-decimal (x.x.x.x) notation. On
the Network > Routing > OSPF window, the area ID will always be displayed
in dotted-decimal notation. For example, 0.0.0.1 will be displayed if you
type 1 as the area ID and 0.0.1.0 will be displayed if you type 256 as the
area ID.
5. For Cost, type the cost (metric) of this route.
6. For Hello Interval, type the route’s hello interval.