TMS zl Management and Configuration Guide ST.1.1.100430

9-60
Routing
Multicast
Figure 9-25. Enable Multicast on Interface Window
5. For Interface, select an interface from the list. The interfaces listed are
TMS VLANs and GRE tunnels (on which multicast routing has not already
been enabled).
To learn how to create TMS VLANs, see “Plan the Zones” in Chapter 2:
“Initial Setup in Routing Mode.” To learn how to create GRE tunnel
interfaces, see, “Configure a GRE Tunnel” in Chapter 7: “Virtual Private
Networks.”
6. For IGMP Enabled, select yes or no. Typically, you should select yes.
7. For DR Priority, select the priority of the TMS zl Module in DR election on
the interface.
8. Click OK.
9. Repeat steps 4. through 8. for each interface that supports multicast
routing.
Viewing Multicast Routes
To see which multicast routes are active, follow these steps:
1. Click Network > Routing, then click the View Routes tab.
Figure 9-26. Select Multicast Routes