TMS zl Management and Configuration Guide ST.1.1.100430

10-117
Troubleshooting
Troubleshooting the TMS zl Module in Routing Mode
ProCurve Switch (tms-module-D:config)# capture <terminal
| file> any <extended options>
You can use the extended options shown in Table 10-20 to capture certain
types of traffic, based on protocol or Ethernet packet type, source IP address,
destination IP address, source port, or destination port. You can specify
several combinations of the extended options, and you can enter the options
in almost any order.
Table 10-20. capture Extended Options
You may also want to limit the number of packets that are captured. For
example, you might enter the following command to view 100 HA packets:
ProCurve(tms-module-<slot ID>: config)# capture terminal
ha pktcount 100
For more information about the capture command, see “capture” on page A-28
in Appendix A: “Command-Line Reference.”
Extended Command Option Purpose
sip <source IP address> Specifies the source IP address of the packet to be captured
dip <destination IP address> Specifies the destination IP address of the packet to be captured
host <host ip address> Specifies the IP address to match to either source or destination address
sp <source port> Specifies the source port of the packet to be captured
dp <destination port> Specifies the destination port of the packet to be captured
port <port number> Specifies that all traffic sent or received on this port will be captured.
ether <network protocol type> Specifies the network protocol of the packet to be captured
•ip
•arp
•rarp
•atalk
•aarp
• decnet
•sca
•lat
• mopdl
•moprc
•iso
•stp
•ipx
• netbeui
ip <transport protocol type> Specifies the transport protocol of the packet to be captured:
•tcp
•udp
•icmp
•igmp
•eigrp
•gre
•lt2p
•pim
•ah
•esp
•vrrp
•ospf
•multicast