TMS zl Management and Configuration Guide ST.1.1.100430

A-10
Command-Line Reference
Overview
Overview
This chapter describes the commands provided by the command line interface
(CLI).
The TMS zl Module CLI is context-based; different commands are available
from different contexts. When you are managing the TMS zl Module and you
try to use a command that is not supported from the current context, you will
receive an error message.
The following sections introduce groups of commands that are available from
various CLI contexts. Note that the module includes a Services OS and a
Product OS, each of which has its own CLI.
Table A-1. CLI Context Command Groups
Figure A-1 shows these command groups and their relationship with one
another.
Command Group Description Prompt (if module is in slot C) Page
Services OS operator
context commands
The commands available from the
operator context of the Services OS
ProCurve(services-module-C)> page A-14
Services OS manager
context commands
The commands available from the
manager context of the Services OS
ProCurve(services-module-C)# page A-17
Services OS show
commands
The show commands available from the
Services OS
ProCurve(services-module-C)# page A-23
Product OS operator
context commands
The commands available from the
operator context of the Product OS
ProCurve(tms-module-C)> page A-25
Product OS manager
context commands
The commands available from the
manager context of the Product OS
ProCurve(tms-module-C)# page A-33
Global configuration
context commands
The commands available from the global
context.
ProCurve(tms-module-C:config)# page A-44
Product OS show
commands
The show commands available from all
contexts of the Product OS
ProCurve(tms-module-C)# page A-189