TMS zl Management and Configuration Guide ST.1.1.100430

A-17
Command-Line Reference
Services OS Manager Context Commands
Services OS Manager Context
Commands
The Services OS manager context allows restricted access to the Services OS
of the module, providing only a limited number of commands. From this mode,
you can download and install software and licenses. CLI access to the Services
OS is designed primarily for blade maintenance, not for configuring the
module.
The Services OS context is used to complete basic setup and maintenance
tasks. To access this context, enter the following command from the switch’s
manager-level or global configuration context:
For example, if you want to enter the Services OS for the TMS zl Module in
slot C, enter one of the following commands:
hostswitch# services c 1
hostswitch# services c name services-module
To verify your location in the CLI, check the prompt. In the Services OS
manager context, the prompt is one of the following:
■ ProCurve(services-module-<slot ID>:HD)#
This is the prompt that is displayed if you have entered the Services OS
CLI and the Services OS is booted.
■ ProCurve(services-module-<slot ID>:PR)#
This is the prompt that is displayed if you have entered the Services OS
CLI and the Product OS is booted.
Syntax: services <slot ID> < <product index> | name <product name> >
Moves you to an OS context on the module.
Replace <slot ID> with the letter for the chassis slot in which
the module is installed.
Replace <product index> with 1. The Services OS context is
always assigned index number 1.
Replace <product name> with services-module. The Services OS
context is always assigned product name services-module.