TMS zl Management and Configuration Guide ST.1.1.100430

A-66
Command-Line Reference
Global Configuration Context
dhcp-relay-enable
This command enables (or disables) DHCP relay for VLANs on the module.
Syntax: [no] dhcp-relay-enable vlan <VLAN ID>
Replace <VLAN ID> with the ID of the VLAN.
For example:
ProCurve(tms-module-<slot ID>:config)# dhcp-relay-enable
vlan 5
Note You cannot delete a VLAN association if DHCP relay is enabled on the VLAN,
even if DHCP is disabled globally.
end
To return to the manager context, enter end. The end command moves you
back to the manager context, regardless of the context where you enter the
command.
Syntax: end
This command is available from all contexts.
erase
This command exits the current session and reboots the router with the
factory default startup-configuration. The TMS zl Module CLI notifies you that
the startup configuration will be restored to the factory default but your IPS
signatures will not be lost) and the module will be rebooted; then it asks if you
want to continue.
Syntax: erase startup-config
Note All of your signatures will be lost if you restore your module to a previous
configuration or to factory default settings.