TMS zl Management and Configuration Guide ST.1.1.100430

A-68
Command-Line Reference
Global Configuration Context
gre <tunnel name> enable
Tunnels are enabled by default, but if a tunnel is disabled, you can enable it
by entering the following command:
Syntax: gre <tunnel name> enable
Replace <tunnel name> with the character string that was configured for
this tunnel.
gre <tunnel name> ip
These commands configure dynamic routing for a GRE tunnel, enabling the
TMS zl Module to exchange RIP and OSPF messages on a GRE tunnel
interface.
gre <tunnel name> ip rip. This command enables (or disables) RIP on the
GRE tunnel interface and configures RIP options for the interface.
Before you can enter any options for RIP, you must enable RIP on the tunnel
interface with this command:
Syntax: [no] gre <tunnel name> ip rip
After RIP is enabled on the tunnel interface, you can configure RIP options
for the GRE tunnel with the following command:
Syntax: [no] gre <tunnel name> ip rip <extended options>
Replace <tunnel name> with name of the GRE tunnel on which you are
enabling or configuring RIP.
The options available for the command are shown in Table A-20.