TMS zl Management and Configuration Guide ST.1.1.100430

A-71

Command-Line Reference

Global Configuration Context

ProCurve(tms-module-<slot ID>:gre-<tunnel name>-pim-

sparse)#

See “GRE PIM Context” on page A-122.

gre <tunnel name> keepalive

This command enables the GRE tunnel keepalive mechanism.

To configure keepalives for GRE tunnel, enter the following command:

Syntax: gre <tunnel name> keepalive <period> <retries>

Replace <tunnel name> with name of the GRE tunnel on which you are

enabling (or disabling) keepalive.

Replace <period> with the number of seconds between sending keepalives

(1 to 3600 seconds).

Replace <retries> with the number of keepalives to which the tunnel inter-

face can fail to receive a reply before the module declares the tunnel to be

down (1 to 255).

To disable keepalives, enter the following command:

Syntax: no gre <tunnel name> keepalive

gre <tunnel name> tunnel

This command creates a GRE tunnel (or deletes). When you create a GRE

tunnel, you must specify the following:

■ Tunnel name

■ Tunnel IP address

■ Firewall zone

■ Local and remote IP addresses

To create a GRE tunnel, enter the following command:

Syntax: gre <tunnel name> tunnel <tunnel IP address> <peer IP address> <zone>

Replace <tunnel name> with a character string that is unique for this tunnel.

The name can be from 1 to 10 alphanumeric characters.It is recommended

that you use a name that indicates the destination of the tunnel.