TMS zl Management and Configuration Guide ST.1.1.100430

A-94
Command-Line Reference
Global Configuration Context
Replace <count> with the number of duplicate events that you want to occur
before the module logs a tally message (1–2147483647). The default number
is 500.
Replace <seconds> with the number of seconds that you want to pass before
the module logs a tally message with the number of duplicate events (150–
2147483647). The default is 600 seconds.
For example, if you want the module to log a tally message that tells you how
many duplicate events have occurred after either 100 of those events occur or
after 5 minutes have passed since the first event was logged, you would enter
the following command:
ProCurve(tms-module-<slot ID>)# logging threshold
duplicates 100 time 300
Log Threshold Monitor. You can enable log threshold monitor to help pre-
vent excessive logging from negatively impacting the TMS zl Module’s perfor-
mance. When enabled, this feature evaluates the logging engine’s resource
consumption on the TMS zl Module. If the resource consumption becomes
high enough to negatively impact the performance of the module, the Logging
Threshold Monitor will reset the log severity threshold to Critical.
Syntax: [no] logging threshold monitor enable
logout
Exit the current CLI session and return to the login screen.
Syntax: logout
management
The management command configures different management settings
depending on the TMS zl Module’s operating mode.
Routing Mode
In routing mode, this command configures your management-access zone and
priority VLAN.
management priority-vlan. To configure the priority VLAN, type the fol-
lowing command:
Syntax: management priority-vlan <vlan ID>