TMS zl Management and Configuration Guide ST.1.1.100430

A-96
Command-Line Reference
Global Configuration Context
For example, to assign the module IP address 10.10.15.72/24, enter the follow-
ing command:
ProCurve Switch 5406zl(tms-module-<slot ID>:config)#
management ip 10.10.15.72 255.255.255.0
management vlan. To configure your management VLAN, enter the follow-
ing command:
Syntax: management vlan <VLAN ID>
Replace <VLAN ID> with the VLAN ID number. The IP address that you assigned
to the module must be part of a subnet associated with this VLAN.
For example, to assign the module’s management VLAN to VLAN 3, enter the
following command:
ProCurve Switch 5406zl(tms-module-<slot ID>:config)#
management vlan 3
nat
You use the nat command to configure all of your NAT policies. Policies specify
several parameters:
■ Type of NAT
■ Source zone
■ Destination zone
■ Service
■ Source address
■ Destination address
The nat command can be used to create (or delete) policies as well as move
policy positions.
nat destination
Enter the following command to create a destination NAT policy:
Syntax: nat destination <source zone> self < protocol | service <service> > <source
address> <destination address> [destination port] nat-ip <NAT destination address>
[NAT port] [extended options]