TMS zl Management and Configuration Guide ST.1.1.100430

A-122
Command-Line Reference
GRE PIM Context
GRE PIM Context
Figure A-13. GRE PIM Context
From this context, which is available only when the TMS zl Module is in
routing mode, you can assign a DR priority for the module on the GRE tunnel.
To enable (or disable) PIM on a GRE tunnel interface and enter the GRE PIM
context, enter the following command from the global configuration context:
Syntax: [no] gre <tunnel name> ip pim-sparse
Replace <tunnel name> with name of the GRE tunnel to on which you are
enabling PIM.
The prompt is ProCurve(tms-module-<slot ID>:gre-<tunnel
name>-pim-sparse)#.
To set the GRE tunnel’s DR priority, enter the following command:
Syntax: dr-priority <priority>
Replace <priority> with the priority of the TMS zl Module during DR elec-
tions (0 to 4294967295). The default priority is 1.