TMS zl Management and Configuration Guide ST.1.1.100430

A-141
Command-Line Reference
IPsec Policy Context
After entering this command, you move to the IPsec IRAS context. See “IPsec
IRAS Context” on page A-150.
key-exchange-method
For the TMS zl Module’s IPsec policies, you can either use manual keys or use
IKE. To set the key exchange method, enter the following command:
Syntax: key-exchange-method <auto | manual>
After you enter this command, you move to the key exchange (manual or auto)
context. In the key exchange context, you will only be able to enter commands
to configure settings for the key exchanged method you set. See “IPsec Auto
Keys Context” on page A-143 or “IPsec Manual Keys Context” on page A-146.
preview
Before you apply the IPsec policy, you should preview it to make sure that
everything is correct. To preview your policy, enter the following command
from any IPsec policy context:
Syntax: preview
The command is also available from other contexts accessed through the
IPsec policy context.
proposal
The IPsec proposal specifies the IPsec mode, IPsec protocol, and the authen-
tication and encryption algorithms that secure the VPN connection. See “ipsec
proposal” on page A-83.
Syntax: proposal <proposal name>
Replace <proposal name> with the name of the proposal you want to apply
to this IPsec policy. This proposal must already by configured on the module.
For example:
ProCurve(tms-module-<slot ID>:ipsec:<action>)# proposal
testprop