TMS zl Management and Configuration Guide ST.1.1.100430

A-154
Command-Line Reference
IPsec Policy Context
To verify your location in the CLI, check the prompt. In the IPsec policy bypass
context, the prompt is:
ProCurve(tms-module-<slot ID>:ipsec:bypass)#
To exit the IPsec policy bypass context, enter the following:
Syntax: exit
If you have not set all of the necessary configurations, you will be prompted
to do so and asked whether you actually want to exit.
The sections below document the commands available from the IPsec policy
bypass context. You can:
■ Set the direction (page A-154)
■ Set the traffic selector (page A-155)
■ Preview the IPsec policy (page A-156)
■ Apply the IPsec Policy (page A-154)
apply
Once you have configured all parts of the IPsec policy, you must apply the
policy. The apply command verifies that all required settings are configured
and then adds or edits the IPsec policy. (If the requirements are not met, the
command does not take effect, and an error message indicates which settings
are missing.) Enter the following command:
Syntax: apply
direction
To set the traffic direction to which the policy is applied, enter the following
command:
Syntax: direction <both | inbound | outbound>
The both option applies the bypass action to traffic both to and from the local
and remote addresses and ports specified in the traffic selector. The inbound
option applies the bypass action only to traffic from the remote addresses and
ports to the local addresses and ports. The outbound option applies the
bypass action only to traffic from the local addresses and ports to the remote
addresses and ports.