TMS zl Management and Configuration Guide ST.1.1.100430

2-17
Initial Setup in Routing Mode
Initial Setup
Access the Host Switch’s CLI
To begin the initial setup, you must first access the TMS zl Module through
the host switch’s command-line interface (CLI), using one of the following
access methods:
■ Console session
■ Telnet session
■ Secure Shell (SSH) session
To establish a console connection with the switch, use the serial cable that
was shipped with the switch to connect a workstation to the switch. Then, run
terminal session software such as Tera Term or HyperTerminal on your
workstation, setting the following parameters for the session:
■ Baud rate = 9600
■ Parity = None
■ Data bits = 8
■ Stop bits = 1
■ Flow control = None
If you are prompted for a password when you access the host switch’s CLI,
enter the password that is configured for the manager user.
Ensure That the Host Switch Recognizes the TMS zl
Module
You should first ensure that the host switch recognizes that the TMS zl Module
is installed in the switch by entering the following command:
hostswitch# show services
Table 2-3 shows an example output for this command.
Notice that two items are listed for each TMS zl Module: Services zl Module
and Threat Management Services zl Module. The Services zl Module is always
displayed first with index number 1. This pattern will hold true for all TMS zl
Modules as well as for HP ProCurve ONE zl Modules.