TMS zl Management and Configuration Guide ST.1.1.100430

2-19
Initial Setup in Routing Mode
Initial Setup
■ The index numbers assigned to products can change. For example, if a
module is rebooted, the index number for the product or products that
run on that module might change. Similarly, when a switch is rebooted or
powered off and on, the index numbers can change.
■ A product is assigned only one index number even if more than one
module runs that product.
You can always check the product index numbers by entering the show
services command. Table 2-4 shows an example output for this command. In
this example, only TMS zl Modules are installed in the host switch, so TMS
will always boot first, and the host switch assigns index number 2 to the TMS
zl Module.
Table 2-4. CLI Display of Services Example 1
Table 2-5 shows another example of the output for the show services com-
mand. In this example, two TMS zl Modules and a ONE Services zl Module
running Data Center Connection Manager (DCM) are installed on the switch.
The module running DCM booted first so it was assigned index number 2. The
TMS zl Modules booted later, so they were assigned index number 3.
Table 2-5. CLI Display of Services Example 2
Whenever you reboot the host switch, a TMS zl Module, or a ONE Services zl
Module, you should enter the show services command to check the index
numbers.
Access the TMS zl Module Services OS Context
The Services OS context is used to complete basic setup and maintenance
tasks. You will configure the TMS zl Module itself from the Product OS context.
(See “Access the TMS zl Module Product OS Context” on page 2-31.) However,
you cannot access this context until you have activated the module and booted
it to the Product OS.
Slot Index Description Name
C,E 1. Services zl Module services-module
C,E 2. Threat Management Services zl Module tms-module
Slot Index Description Name
C,D, E 1. Services zl Module services-module
D 2. Data Center Connection Manager dcm
C,E 3. Threat Management Services zl Module tms-module