TMS zl Management and Configuration Guide ST.1.1.100430

2-34

Initial Setup in Routing Mode

Configure Management Access Settings

Before you can access the Web browser interface and begin configuring the

TMS zl Module, you must access the CLI and complete these tasks:

■ Enable management access on a zone.

■ Optionally, configure a priority VLAN.

■ Associate a VLAN with the zone.

■ Configure a static IP address for the VLAN.

■ Configure the default gateway.

To begin configuring these settings, complete these steps.

1. Access the host switch’s CLI. If you do not remember the index number

for the TMS zl Module, enter this command:

hostswitch# show services

2. Enter the Product OS context:

The prompt should look like the following:

hostswitch(tms-module-C)#

3. Enter the global configuration context for the module:

hostswitch(tms-module-C)# configure terminal

Syntax: services <slot ID> < <product index> | name <product name> >

Moves you to an OS context on the module.

Replace <slot ID> with the letter for the chassis slot in

which the module is installed.

Replace <product index> with the product index assigned

tot he TMS zl Module. See “Understanding Index Num-

bers” on page 2-18.

Replace <product name> with tms-module. The TMS zl Mod-

ule’s Product OS context is always assigned the product

name tms-module.

Syntax: configure terminal

Enters the configuration context for the module.