TMS zl Management and Configuration Guide ST.1.1.100430

2-41

Initial Setup in Routing Mode

Configure Management Access Settings

For example, you might enter:

hostswitch (tms-module-C:config)# ping 10.1.99.101

PING 10.1.99.101(10.1.99.101) 56(84) bytes of data.

64 bytes from 10.1.99.101: icmp_seq=1 ttl=255

time=1.54 ms

64 bytes from 10.1.99.101: icmp_seq=2 ttl=255

time=0.515 ms

64 bytes from 10.1.99.101: icmp_seq=3 ttl=255

time=0.526 ms

b. If the default gateway is not in a management-access zone, the TMS zl

Module will block ICMP echo packets between the Self zone and the

gateway’s zone until you create an access policy to allow this traffic.

i. Create an access policy to permit ICMP echo packets between

the Self zone and the gateway’s zone:

ii. Ping the default gateway.

hostswitch (tms-module-C:config)# ping <default

gateway>

Syntax: access-policy self <destination zone> permit icmp echo host

Creates an access policy to allow pings from the TMS

zl Module to another device.

Replace <destination zone> with the default gateway’s

zone.

Replace <source address> with the TMS zl Module’s IP

address on the VLAN that connects to the default

gateway.

Replace <destination address> with the default gate-

way’s IP address.

For a complete list of all options available for the

access-policy command, see “access-policy” in Appen-

dix A: “Command-Line Reference.”