TMS zl Management and Configuration Guide ST.1.1.100430

2-59
Initial Setup in Routing Mode
Modify Management Settings
Figure 2-28. System > Settings > Operating Mode Window
2. Select Routing. See “Operating Modes” in Chapter 1: “Overview” for an
explanation of the operating modes.
3. Click Apply My Changes.
4. A warning box is displayed, informing you that you must reboot the TMS
zl Module to apply the change:
•Click Save & reboot to save your configuration changes and reboot the
TMS zl Module.
•Click Reboot without saving to reboot the TMS zl Module without
saving any changes that have not yet been saved.
Whichever choice you make, the TMS zl Module reboots in the new operating
mode with the last configuration made for that operating mode. If the module
has not been configured in this operating mode before, it is booted at the
factory default settings. To learn how to set up the module for management
access in the new mode, see:
■ “Initial Setup” on page 2-16 for routing mode
■ “Configure Initial Settings” on page 3-25 of Chapter 3: “Initial Setup in
Monitor Mode” for monitor mode
Change the Passwords for the Local Manager and
Operator
To protect your network, ProCurve Networking strongly recommends that
you immediately change the passwords for the manager and operator
accounts.