TMS zl Management and Configuration Guide ST.1.1.100430

2-72
Initial Setup in Routing Mode
Configure DHCP Relay and DNS Server Settings
Follow these steps to configure DHCP relay:
1. Click Network > Settings and click the DHCP Relay tab.
Figure 2-37. Network > Settings > DHCP Relay Window
2. For Message relay, select On.
3. Specify up to four DHCP servers. To start, type the IP address for DHCP
Server 1.
4. The Relay messages for selected VLANs list displays all of your TMS VLANs.
Select the check box next to each VLAN for which you want to enable
DHCP relay.
To save time, you can use the Select All and Clear All buttons to enable or
disable DHCP relay for all of your TMS VLANs at once. You can then select
or clear individual check boxes as necessary.
5. Click Apply My Changes.